光束发散度对紫外写入光纤光栅的影响

用傅里叶衍射光学分析了准分子激光束发散度对于光纤光栅制备的影响，发现光束发散角使光纤光栅的布拉格波长发生改变，相位版后干涉场沿光纤轴向和径向不均匀，对制备30dB高反射率光纤光栅造成困难。实验结果与理论分析基本一致，相对于理想平行光束情况，会聚光束使得光纤光栅布拉格波长出现在短波一边，发射光束使得光纤光栅布拉格波长出现在长波一边。     

油水两液相一维非等温渗流的传递分析

在求解油水两液相非等温渗流的温度场、压力场基础上,以驱动功、驱动功率、驱动阻力、驱动速率为特征参数,对该过程进行(火用)传递分析。数值模拟的结果表明:含水通过降低油的相对渗透率、从而增大驱动阻力、减小驱动功率, 最终导致原油产量降低。     

一类小缺陷码的链条件

利用射影几何方法在小缺陷码中,NMDS码是链条件码;给出k维NμMDS(0μk-2)码满足链条件的一个充要条件与一些易判断的充分条件.     

烟气中Hg的氧化机理的研究

本文对Ｈｇ与Ｃｌ２在烟气中的氧化反应进行了热力平衡计算和动力学计算。平衡计算的结果表明有ＣＩ元索存在时Ｈｇ的氧化率为１００％，而在相同的条件下动力学计算纺果为Ｈｇ的氧化率在２０％～８０％之间变化，与实验结果吻合。实际的氧化反应是一种超平衡状态，不能达到理想的平衡状态。因此应采用动力学与热力平衡分析相结合的方法研究Ｈｇ在烟气中的反应机理。同时，计算结果显示Ｃｌ含量对Ｈｇ的氧化率的影响很大．     

The Calibrating Theory in the Network Parameters Measurement of Microwave and MMW Devices

The paper introduces a special system calibration technology in s-parameters measurement of microwave and millimeter wave devices. The 8-term errors module is built by analyzing the signals flowing in the measurement system. Then the calibration technology using non-standard kits is designed on the base. Finally, the experiment using the calibration technology is introduced.     

Nanostructured thermoset epoxy resin templated by an amphiphilic poly(ethylene oxide)‐block‐poly(dimethylsiloxane) diblock copolymer

An amphiphilic poly(ethylene oxide)‐block‐poly(dimethylsiloxane) (PEO–PDMS) diblock copolymer was used to template a bisphenol A type epoxy resin (ER); nanostructured thermoset blends of ER and PEO–PDMS were prepared with 4,4′‐methylenedianiline (MDA) as the curing agent. The phase behavior, crystallization, hydrogen‐bonding interactions, and nanoscale structures were investigated with differential scanning calorimetry, Fourier transform infrared spectroscopy, transmission electron microscopy, and small‐angle X‐ray scattering. The uncured ER was miscible with the poly(ethylene oxide) block of PEO–PDMS, and the uncured blends were not macroscopically phase‐separated. Macroscopic phase separation took place in the MDA‐cured ER/PEO–PDMS blends containing 60–80 wt % PEO–PDMS diblock copolymer. However, the composition‐dependent nanostructures were formed in the cured blends with 10–50 wt % PEO–PDMS, which did not show macroscopic phase separation. The poly(dimethylsiloxane) microdomains with sizes of 10–20 nm were dispersed in a continuous ER‐rich phase; the average distance between the neighboring microdomains was in the range of 20–50 nm. The miscibility between the cured ER and the poly(ethylene oxide) block of PEO–PDMS was ascribed to the favorable hydrogen‐bonding interaction. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 3042–3052, 2006     

网络环境下的物理实验教学模式

目前网络环境下的物理实验教学新模式主要有物理实验专题网站、实验教学网络管理、实验类网络课程及远程控制物理实验.本文简要介绍了各个模式的特点及实施方法.     

NA列加权乘积和的完全收敛性

本文讨论了NA和几类加权部分和及加权乘积和的完全收敛性，其中部分结果要优于iid列的已知结论。     

高温水蓄冷空调的原理和理论分析

介绍了一种新型高温水蓄冷空调方案的原理井进行了理论分析。它可利用高至３８℃水的显热或其它材料的相变潜热来蓄冷空调．分析了完全不掺混系统的性能与过冷水流率的关系；给出了完全掺混系统非稳态循环的性能变化；数值计算并讨论了蓄冷水部分掺混系统的温度分层和动态特性、为高温水蓄冷空调系统的设计和运行提供了理论指导．     

Diode-pumped 671 nm laser frequency doubled by CPM LBO

A design of diode-pumped high-efficiency Nd:YVO₄/LBO red laser is reported. Using critical phase-matching (CPM) LBO, 671 nm red laser was obtained from 1342 nm light by intracavity frequency doubling. With an incident pump laser of 800 mW, using type-I and type-II CPM LBO, 97 and 52 mWTEM₀₀ mode red laser outputs were obtained, with optical-to-optical conversion efficiencies of up to 12.1% and 6.5%, respectively.